Server-Side Connectors

This article describes how to set up the Adestra connector in your Customer Data Hub account.

In this article:

Table of Contents Placeholder

Connector Actions

Go to the Connector Marketplace and add a new connector. Read the Connector Overview article for general instructions on how to add a connector.

After adding the connector, configure the following settings:

Click Next or go to the Actions tab. This is where you configure connector actions.

This section describes how to set up parameters and options for each action.

Parameter	Description
Update Strategy	Required. Select applicable update strategy. Create Only Look up an existing contact and if not found, create a new contact. Update Only Look up an existing contact and update it. Create or Update Look up an existing contact and if found, update it, otherwise create a new contact.
Core Table	Required. Select the core table to create or update the contact in.
Contact Lookup Email Address	Required. Email address to lookup contact.

Parameter	Description
Core Table	Required. Select the core table the contact belongs to.
Contact Lookup Email Address	Required. Email address to lookup contact.
List	Required. List to add the contact to.

Parameter	Description
Core Table	Required. Core tables store contacts in Adestra. Select the core table the contact belongs to.
Contact Email Address	Required. Email address to lookup contact.
List	Required. List to remove the contact from.

Parameter	Description
Email Campaign	Required. Select the campaign to be launched.
Contact Email Address	Required. Email address to send email to.
Transaction Data	Required. Template data to set within the email campaign.