Basis Technologies DSP Connector Setup Guide

[#1]

This article describes how to set up the Basis Technologies DSP connector.

In this article:

• Connector Actions
• Configure Settings
• Action Settings — Parameters and Options
• Action — Add User to Audience Segment

Connector Actions

Action Name	AudienceStream	EventStream
Add User to Audience Segment	✓	✓

Configure Settings

Navigate to the Connector Marketplace and add a new connector. For general instructions on how to add a connector, see the About Connectors article.

After adding the connector, configure the following settings:

• Advertiser ID
  Required: Your Basis Technologies Advertiser ID.
• Audience Segment
  Optional: To create a new audience segment in Basis Technologies DSP, click New Audience Segment.

Click Done when you are finished configuring the connector.

Action Settings — Parameters and Options

Click Continue to configure the connector actions. Enter in a name for the action and then select the action type from the drop-down menu.

The following section describes how to set up parameters and options for each action.

Action — Add User to Audience Segment

Parameters

Parameter	Description
Audience Segment to Add User To	Required. Select your audience segment or click New Audience Segment to create a new audience segment in Basis Technologies DSP.
Basis Technologies Cookie ID	Required. Basis Technologies Cookie ID.