Mailgun Connector Setup Guide

[#1]

This article describes how to set up the Mailgun connector.

In this article:

• Connector Actions
• Configure Settings
• Action Settings - Parameters and Options
• Action - Send Email
• Action - Add Member to List
• Action - Update Member in List

Connector Actions

Action Name	AudienceStream	EventStream
Send Email	✓	✓
Add Member to List	✓	✗
Update Member in List	✓	✗

Configure Settings

Go to the Connector Marketplace and add a new connector. Read the Connector Overview article for general instructions on how to add a connector.

After adding the connector, configure the following settings:

• Password
  • Your API key is the password.
  • Click the Security tab under the Account section of the control panel to manage your API key.
  • For more information on authentication, visit: Mailgun API Reference: Authentication.

Action Settings - Parameters and Options

Click Next or go to the Actions tab. This is where you configure connector actions.

This section describes how to set up parameters and options for each action.

Action - Send Email

Parameters

Parameter	Description
My Domain	The domain of your Mailgun account. For more information, see: Mailgun API Reference: Base URL.
From	Email address of the sender. For more information on this endpoint, see: Mailgun API Reference: Messaging > Sending.
To	Email address of the recipient. Example: bob@host.com or Bob <bob@host.com>.
Subject	Message subject.
Text	Body of the message.
Additional Parameters	Additional optional parameters. For more information on these fields, see: Mailgun API Reference: Messaging > Sending.

Action - Add Member to List

Parameters

Parameter	Description
List Address	Address of your list. Example: LIST@YOUR_DOMAIN_NAME.COM For more information on this endpoint, see: Mailgun API Reference: Mailing Lists.
Member Address	Valid email address of the member being added.
Name	Optional member name.
Subscribed	Values are Yes or No. The default value is Yes. Yes to add as subscribed. No to add as unsubscribed.
Upsert	Values are Yes or No. The default value is No. Yes to update member if present. No to raise error in case of a duplicate member.
Additional Parameters	Optional additional parameters. Example: gender, age.

Action - Update Member in List

Parameters

Parameter	Description
List Address	Address of your list. Example: LIST@YOUR_DOMAIN_NAME.COM For more information on this endpoint, see see: Mailgun API Reference: Mailing Lists.
Member Address	Valid email address of member.
Name	Optional member name.
Subscribed	Values are Yes or No. Yes for subscribed. No for unsubscribed.
Additional Parameters	Optional additional parameters. Example: gender, age.