This article describes how to set up the SmartSurvey connector in your Customer Data Hub account.

In this article:
Table of Contents Placeholder

Connector Actions

Action Name AudienceStream EventStream
Add Contact to List

Configure Settings

Go to the Connector Marketplace and add a new connector. Read the Connector Overview article for general instructions on how to add a connector.

After adding the connector, configure the following settings:

Action Settings - Parameters and Options

Click Next or go to the Actions tab. This is where you configure connector actions.

This section describes how to set up parameters and options for each action.

Action - Add Contact to List


Parameter Description
Contact list ID
  • The email address for the contact.
  • The name of the contact.
Custom Fields
  • Custom data fields pertaining to the contact.