Back

This article describes how to set up the ActiveCampaign connector in your Universal Data Hub account.

In this article:

Table of Contents Placeholder

Connector Actions

Action Name AudienceStream EventStream
Add New Contact
Add Tags to Contact
Add Contact to Automation

Configure Settings

Go to the Connector Marketplace and add a new connector. Read the Connector Overview article for general instructions on how to add a connector.

After adding the connector, configure the following settings:

Action Settings - Parameters and Options

Click Next or go to the Actions tab. This is where you configure connector actions.

This section describes how to set up parameters and options for each action.

Action - Add New Contact

Parameters

Parameter Description
Email
  • Email of the new contact. for example, 'test@example.com'.
List ID
  • Assign a contact to a list.
  • Specify the integer value of the list, for example, 12345.
Additional Fields

Action - Add Tags to Contact

Parameters

Parameter Description
Email
  • Email of the new contact, for example 'test@example.com'.
Tags
  • Tags to add to the contact.
  • Pass a string for one tag, an array (set of strings) for multiple tags, or a comma-separated list of custom values.

Action - Add Contact to Automation

Parameters

Parameter Description
Contact Email
  • Email of the new contact, for example, 'test@example.com'.
Automation IDs
  • The automation IDs to add the contact to.
  • You may use multiple, comma-separated values.