Back

This article describes how to set up the Chameleon connector in your Universal Data Hub account.

Table of Contents Placeholder

Connector Actions

Action Name AudienceStream EventStream
Create User
Update User

Configure Settings

Go to the Connector Marketplace and add a new connector. Read the Connector Overview article for general instructions on how to add a connector.

After adding the connector, configure the following settings:

Action Settings - Parameters and Options

Click Next or go to the Actions tab. This is where you configure connector actions.

This section describes how to set up parameters and options for each action.

Action - Create User

Parameters

Parameter Description
User ID
Email
  • An email address to connect their data in integrations you enable.
User Data
  • Any and all parameters pertinent to the user.

Action - Update User

Parameters

Parameter Description
User ID
Email
  • An email address to connect their data in integrations you enable.
User Data
  • Any and all parameters pertinent to the user.