Back

This article describes how to set up the madvertise connector in your Universal Data Hub account.

In this article:

Table of Contents Placeholder

Connector Actions

Action Name AudienceStream EventStream
iOS Install
Android Install
Send Custom Event

Configure Settings

Go to the Connector Marketplace and add a new connector. Read the Connector Overview article for general instructions on how to add a connector.

After adding the connector, configure the following settings:

Action Settings - Parameters and Options

Click Next or go to the Actions tab. This is where you configure connector actions.

This section describes how to set up parameters and options for each action.

Action - iOS Install

Parameters

Parameter Description
Click ID Custom
IDFA Custom
Device IP Custom

Action - Android Install

Parameters

Parameter Description
Click ID Custom
GAID Custom
Device IP Custom

Action - Send Custom Event

Parameters

Parameter Description
Event Name Custom
Click ID Custom