Back

This article describes how to set up the Mailrelay connector in your Universal Data Hub (UDH) account.

In this article:

Table of Contents Placeholder

Connector Actions

Action Name AudienceStream EventStream
Add Subscriber

Configure Settings

Go to the Connector Marketplace and add a new connector. Read the Connector Overview article for general instructions on how to add a connector.

After adding the connector, configure the following settings:

Action Settings - Parameters and Options

Click Next or go to the Actions tab. This is where you configure connector actions.

This section describes how to set up parameters and options for each action.

Action - Add Subscriber

Parameters

Parameter Description
Your Account
API key
  • Your API key.
  • Found in your account under settings.
Email
  • Email address of the subscriber.
Name
  • Name of the subscriber.