Back

This article describes how to set up the Sarbacane connector in your Universal Data Hub account.

In this article:

Table of Contents Placeholder

Connector Actions

Action Name AudienceStream EventStream
Add or Edit a Contact
Add Recipients to a Campaign

Configure Settings

Go to the Connector Marketplace and add a new connector. Read the Connector Overview article for general instructions on how to add a connector.

After adding the connector, configure the following settings:

Action Settings - Parameters and Options

Click Next or go to the Actions tab. This is where you configure connector actions.

This section describes how to set up parameters and options for each action.

Action - Add or Edit a Contact

Parameters

Parameter Description
List ID
Email
  • The email of the contact.
  • Must use either email and/or phone.
Phone
  • Phone number of the contact.
  • Must use either email and/or phone.
Field ID's

Action - Add Recipients to a Campaign

Parameters

Parameter Description
Campaign ID
Email
  • The email of the contact.
  • Must use either email and/or phone.
Phone
  • Phone number of the contact.
  • Must use either email and/or phone.