Back

This article describes how to set up the SendPulse connector in your Universal Data Hub account.

In this article:

Table of Contents Placeholder

Connector Actions

Action Name AudienceStream EventStream
Add Email to Mailing List (single opt-in)
Add Email to Mailing List (double opt-in)
Delete Email from Mailing List

Configure Settings

Go to the Connector Marketplace and add a new connector. Read the Connector Overview article for general instructions on how to add a connector.

After adding the connector, configure the following settings:

Action Settings - Parameters and Options

Click Next or go to the Actions tab. This is where you configure connector actions.

This section describes how to set up parameters and options for each action.

Action - Add Email to Mailing List (single opt-in)

Parameters

Parameter Description
List ID
Email
  • Email address of the user to be added to the list.

Action - Add Email to Mailing List (double opt-in)

Parameters

Parameter Description
List ID
Sender Email
  • Your sender email.
  • Sender email address must be activated in your SendPulse account in Email-Service settings-From address menu.
Email
  • Email address of the user to be added to the list.

Action - Delete Email from Mailing List

Parameters

Parameter Description
List ID
Email
  • Email address to be deleted from list.