Back

This article describes how to set up the Tamber connector in your Universal Data Hub (UDH) account.

Table of Contents Placeholder

Connector Actions

Action Name AudienceStream EventStream
Send Event

Configure Settings

Go to the Connector Marketplace and add a new connector. Read the Connector Overview article for general instructions on how to add a connector.

After adding the connector, configure the following settings:

  • Project Key
    • Most requests can be made with only a Project key.
    • All requests can be made with only an Engine key, as the Project will be automatically inferred.
    • For more information, see: https://tamber.com/docs/api/#authentication
  • Engine Key
    • Most requests can be made with only a Project key.
    • All requests can be made with only an Engine key, as the Project will be automatically inferred.
    • For more information, see: https://tamber.com/docs/api/#authentication

Action Settings - Parameters and Options

Click Next or go to the Actions tab. This is where you configure connector actions.

This section describes how to set up parameters and options for each action.

Action - Send Event

Parameters

Parameter Description
User
Behavior
  • The unique behavior name.
Item
  • Item associated with the event.
Amount
  • The amount that the behavior was performed.
  • Example: Percentage of the movie that was watched, rating given, etc.).
  • Defaults to 1.0 if a value is not supplied.
Created
  • Time the event occurred.
  • Defaults to the current time if a value is not supplied.
Hit
  • Set to true to indicate that the event represents a successful recommendation.
  • Example: The item in the event was presented to the user as a recommendation.
Context Data
  • The context in which the event occurred.
  • Useful for segmenting events data to determine the impact of interface elements and other contextual variables on user behavior.
  • Also useful for A/B testing interface changes.